I've been working on this project over the past couple of months and have finally got it all together. It's basically just a little T-Amp running from a battery bank that I power with a solar panel. I had the idea a little while ago as it pretty much all fits together nicely since the T-Amp is designed to run from a 12Volt battery source, and it just so happens many solar panels are designed for charging just this type of battery. Searching on the net I found someone had already done this as well as outlined on an article on New Consumer. And searching for that article to add the link to this post I see someone has recently posted an instructable for this same idea as well.

But anyways, I thought I'd post what I did anyways even if it's not unique :)

The first thing I did was get a reasonably sized solar panel. I ended up finding a 40 watt SL040 Sunlink PV panel on ebay, sold new from a seller in Toronto who runs a store on ebay called Go Green Energy. The panel was about $320 all said and done and it came with a charge controller as well. This panel is rated at 17.2 volts at 2.33 amps, however since I am charging a 12 volt system with it my effective wattage form the panel is ~28W, but it seems to output that even on cloudy conditions and such which is why I think the panel is designed to be 17.2 volts. It's a little bit wasteful in full sunlight, but does work in a wider range of partial sunlight conditions. (At least thats how I understand it. I'm no expert). It's also pretty small measuring 25"x21" so it fits on our little porch without having to do any work mounting it to the roof or anything.
















So with the panel I was able to hook the T-Amp directly to the battery terminals from the charge controller and listen to music when it was daylight. However I needed to get some batteries so I could keep it running beyond that. I managed to get two Interstate Workaholic U2200 Deep Cycle batteries from a guy at work for free which was a pretty good score as they would be around $80 each to buy I believe. These are 6 volt batteries with 220 amp hour rating. I hooked them up in series and so I have a 12V battery bank with lots of power now. This should be enough to run the T-Amp for 200+ hours. I'll probably end up hooking up some other 12 volt items to this bank though as the panel should be able to keep the battery charged pretty easily.

To wire everything up I've run the solar panel into the charge controller (as seen in the photo below). I then have the positive feed from the charge controller running to the battery where it is fused off with a 4 amp automotive fuse as close to the battery as possible. The negative lead simply runs directly to the battery. I then have the T-Amp power running to the positive terminal where it is fused off with a 5 amp fuse in another automotive fuse holder. (I purchased the fuses and fuse holders from the automotive section at canadian tire). And the negative lead from the T-amp wried in directly to the negative side of the battery terminal as well. You can also see the jumper cable I'm using in between the two batteries to wire them in series (connecting the positive post of one battery to the negative post on the other battery.

And thats pretty much it. I've been running it on the battery bank now for a week or two and it's been working like a charm.

posted at: 20:21 | path: /energy | permanent link to this entry